Applying Ukfn Graphics Options

[Damon]

This guide is intended to assist you in applying the UKFN vinyl graphics to your vehicle. The guide is written based on the two colour sticker option, however it is just as applicable to the single colour option as well.

The vinyl should be applied to a clean, dry surface. The vinyl will adhere to a warm surface better than a cold one, so if you can warm up the surface before application then this will make the job a bit easier.

First, place the sticker face down and peel away the backing paper. As shown in the image, peel it back on itself and try to keep it close to the surface. This helps to avoid the vinyl remaining stuck on the backing paper.




Next, carefully line the sticker up onto the surface you are applying it to and press on gently.




Using one of those random never-used plastic cards we all have in our wallets, smooth down the vinyl. Apply gentle pressure at first to push any trapped air bubbles out, then increase the pressure to stick down the vinyl properly.




Once you are happy that the vinyl is stuck down, carefully peel back the application tape. Be aware that the tape is very sticky, so take your time to be sure you don't accidentally remove the lettering from the surface. As you did with the backing paper, peel the application tape back on itself keeping it close to the surface.




With that out of the way, remove the backing paper from the "fiesta" section (same as above) and line it up in the space.




Pick up the previously pointless bit of plastic and smooth down the vinyl (same as above)




Carefully peel back the application tape and you're done.